Can Am Maverick X3 Fire Extinguisher Mount Adapter

Installation

This adapter can only be used if the 3 point inertia reel seat belt has been removed and replaced with a 4 point system.

Installation Time: 30 Minutes
6 Installation Steps
Difficulty: Easy

Tools

  • Phillips Head Screwdriver
  • 1/2 Socket or Wrench

Follow these steps for Installation

  1. Remove two screws holding cover to gain access for top bolt.
  2. Install a steel washer on 1/4 20 3.5 inch bolts then insert through adapter plate holes as shown, next install a black shoulder washers as shown.
  3. Hold adapter plate in position sliding bolts through 1/2 inch pipe holes where inertia reel was installed.
  4. Install black shoulder washer then steel washer then nut on each bolt.
  5. As you tighten nut make sure shoulder washers center bolt in hole. As you finish tightening bolt shoulder washers will get pulled into hole to keep it centered in hole.
  6. Now install flat mount as shown using the 4 – 10-32 screws.

See Also:

For instructions on assembling fire extinguisher mount go to: Tek208 Quick Release