TEK208-RTP175C Roll bar mount for Rotopax™ fuel packs

Installation

This installation will cover how to install a TEK208 roll bar mount for Rotopax™ fuel packs.

Installation Time: 30 Minutes
3 Installation Steps
Difficulty: Moderate

Tools

  • 1/4″ Allen Wrench
  • 5/32″ Allen Wrench

Parts

Step 1-2
  1. Using 4 – ¼-20 x 2” SHCS bolts, install ring sets (red in picture) on to roll bar with angle plate (green in picture). Changing the ring sets 90° will change finally angle of fuel can by 10°. Tighten just enough to hold in place.
  2. Using 2-5/16-18 x 1.125” SHCS bolts, mount stub (blue in picture) to angle plate (green in picture). These holes will change angle of stub by 20°. If angle needs to shift one way or other pick different holes in (1) above to change angle by 10°. When satisfied with angle and orientation fully tighten all screws to not more than 60 in/lbs.

Step 3
  1. Install fuel jug over stub then screw on Rotopax™ handle, Fuelpax™ handle or TEK208™ Lockplate (gray in picture) until fuel jug is secure.